离子氮化对H13钢表面CrTiAlN 镀层结合强度的影响

葛培林, 刘小萍, 尚魁平, 冶艳, 鲍明东

表面技术 ›› 2012, Vol. 41 ›› Issue (2) : 79-81.

PDF(3280 KB)
PDF(3280 KB)
表面技术 ›› 2012, Vol. 41 ›› Issue (2) : 79-81.
应用技术

离子氮化对H13钢表面CrTiAlN 镀层结合强度的影响

  • 葛培林1, 刘小萍1, 尚魁平2, 冶艳2, 鲍明东2
作者信息 +

The Influence of Prior Plasma Nitriding on the Adhesion Strength of CrTiAlN Coating Formed on H13 Steel

  • GE Pei-lin1, GE Pei-lin1, GE Pei-lin2, GE Pei-lin2, GE Pei-lin2
Author information +
文章历史 +

摘要

在经过离子氮化处理的H13钢基体上,采用闭合场非平衡磁控溅射法制备了CrTiAlN 硬质涂层,并与未氮化的镀膜试样进行了膜基结合强度、膜层微观结构形貌及相组成的对比。结果表明:离子氮化处理可提高基体硬度,形成硬度梯度过渡;氮化+镀膜复合处理可以显著提高膜基结合强度。

Abstract

A nitride layer was first formed on H13 steel samples by plasma nitriding and then a CrTiAlN coating was prepared on the surface of nitrided and non-nitrided H13 steels using closed field unbalanced magnetron sputter ion plating. The adhesion strength, the microstructure and phase structure of the film were compared between nitrided and non-nitrided H13.The results show that the substrate hardness increases after plasma nitridation and exhibits a gradient hardness transition. The complex treatment of plasma nitridation and CrTiAlN coatings could increase the adhesion strength significantly.

关键词

离子氮化;磁控溅射;渗氮层;CrTiAlN 薄膜;结合强度

Key words

plasma nitriding; magnetron sputtering; nitrided layer; CrTiAlN coating; adhesion strength

引用本文

导出引用
葛培林, 刘小萍, 尚魁平, 冶艳, 鲍明东. 离子氮化对H13钢表面CrTiAlN 镀层结合强度的影响[J]. 表面技术. 2012, 41(2): 79-81
GE Pei-lin, GE Pei-lin, GE Pei-lin, GE Pei-lin, GE Pei-lin. The Influence of Prior Plasma Nitriding on the Adhesion Strength of CrTiAlN Coating Formed on H13 Steel[J]. Surface Technology. 2012, 41(2): 79-81

PDF(3280 KB)

Accesses

Citation

Detail

段落导航
相关文章

/