| ZHANG Wen-chao,WU Mei-ping,REN Zhong-he.Analysis of Jet Flow Machining Parameters Based on LS-DYNA Simula-tion[J],46(10):268-276 |
| Analysis of Jet Flow Machining Parameters Based on LS-DYNA Simula-tion |
| Received:June 20, 2017 Revised:October 20, 2017 |
| View Full Text View/Add Comment Download reader |
| DOI：10.16490/j.cnki.issn.1001-3660.2017.10.040 |
| KeyWord:abrasive water jet LS-DYNA SPH-FEM technological parameters cutting depth |
| Author | Institution |
| ZHANG Wen-chao |
Jiangsu Provincial Key Laboratory of Advanced Food Manufacturing Equipment and Technology, Jiangnan University, Wuxi , China |
| WU Mei-ping |
Jiangsu Provincial Key Laboratory of Advanced Food Manufacturing Equipment and Technology, Jiangnan University, Wuxi , China |
| REN Zhong-he |
Jiangsu Provincial Key Laboratory of Advanced Food Manufacturing Equipment and Technology, Jiangnan University, Wuxi , China |
|
| Hits: |
| Download times: |
| Abstract: |
| The work aims to study effects of relevant technological parameters on cutting parameters by simulating abrasive jet flow erosion and cutting with LS-DYNA. Based on the single abrasive water jet single-point erosion simulation and cutting simulation, both water and abrasive particles were modeled in the method of SPH, alumina ceramic workpiece was modeled in the method of FEM, and jet erosion and cutting process was simulated through SPH-FEM coupling algorithm. According to simulation analysis of jet erosion process and cutting process, abrasive collision and rebound contributed to irregular "V" type wall in early stage of jet machining. At the initial phase, cutting depth increased linearly as time prolonged; the wall had a restrictive effect on the abrasives, therefore hole depth in machining position no longer increased. The abrasives erosion at the bottom of the wall enabled the pit bottom width to increase and tend to be stable rapidly. Meanwhile, there is certain difference between cutting simulation and erosion simulation as the cutting process has set movement speed. Comparison of simulation results with experimental results shows that cutting depth increases linearly as pump pressure increases, increases as the abrasive flow rate increases, and decreases as target distance and traverse speed increases. The cutting depth has nonlinear relationship with abrasive flow rate, target distance and traverse speed; maximum workpiece cutting depth does not grow linearly as and calculation time prolongs. |
| Close |
|
|
|