柯德庆,潘应君,童向阳.纯铜表面等离子喷焊 Ni 60 涂层组织及性能的研究[J].表面技术,2013,42(4):91-93.
KE De-qing,PAN Ying-jun,TONG Xiang-yang.Study on the Microstructure and Properties of Ni 60 Coating by Plasma Spray Welding on Copper[J].Surface Technology,2013,42(4):91-93 |
| 纯铜表面等离子喷焊 Ni 60 涂层组织及性能的研究 |
| Study on the Microstructure and Properties of Ni 60 Coating by Plasma Spray Welding on Copper |
| 投稿时间：2013-03-12 修订日期：2013-04-18 |
| DOI： |
| 中文关键词: 等离子喷焊 纯铜 稀释率 耐磨性能 |
| 英文关键词:plasma spray welding copper dilution rate wear-resistant |
| 基金项目: |
| 作者 | 单位 |
| 柯德庆 | 武汉科技大学 材料与冶金学院, 武汉 430081 |
| 潘应君 | 武汉科技大学 材料与冶金学院, 武汉 430081 |
| 童向阳 | 武汉材料保护研究所, 武汉 430030 |
|
| Author | Institution |
| KE De-qing | Materials and Metallurgy College,Wuhan University of Science and Technology,Wuhan 430081 , China |
| PAN Ying-jun | Materials and Metallurgy College,Wuhan University of Science and Technology,Wuhan 430081 , China |
| TONG Xiang-yang | Wuhan Research Institute of Materials Protection, Wuhan 430030 , China |
|
| 摘要点击次数: |
| 全文下载次数: |
| 中文摘要: |
| 采用等离子喷焊工艺在纯铜基体表面成功制备了 Ni60 焊层,并对其微观形貌、元素成分、显微硬度及耐磨性能进行分析。 分析表明:焊层与基体呈现良好的冶金结合,稀释率仅为 5% 左右,且其显微组织呈细小枝晶状,硬质相呈弥散分布,焊层显微硬度高达 606 HV,耐磨性能较 Cu-Ni 合金焊层提高了 1 倍。 |
| 英文摘要: |
| Ni60 coating was successfully prepared by plasma spray welding process, and its microstructure, elemental composition, micro-hardness and wear-resisting property were analyzed. Results show that, the Ni60 coating presented good metallurgical bonding with copper substrate and the dilution rate was only about 5 % , microstructure like dendritic crystal was present with dispersed hard phase, the micro-hardness of coating had a significant improvement which approached 606 HV, and wear-resistant property increased by 1 times than that of Cu-Ni coating. |
| 查看全文 查看/发表评论 下载PDF阅读器 |
| 关闭 |
|
|
|
渝公网安备 50010702501715号