廖一峰,贺一松,熊龙彪.滚动轴承钢上复合化学镀镍技术的研究[J].表面技术,2008,37(4):15-17.
LIAO Yi-feng,HE Yi-song,XIONG Long-biao.Study on Composite Chemical Ni-plating Technology on Roll Bearing-steel[J].Surface Technology,2008,37(4):15-17 |
| 滚动轴承钢上复合化学镀镍技术的研究 |
| Study on Composite Chemical Ni-plating Technology on Roll Bearing-steel |
| 投稿时间：2008-04-29 修订日期：2008-08-10 |
| DOI： |
| 中文关键词: 轴承钢 化学镀镍 表面形貌 耐磨性 |
| 英文关键词:Bearing-steel Chemical Ni plating Surface morphology Wear resistance |
| 基金项目:韶关市科技计划项目（313-140379） |
| 作者 | 单位 |
| 廖一峰 | 韶关学院信息工程学院，广东韶关512005 |
| 贺一松 | 江西农业大学，江西南昌330045 |
| 熊龙彪 | 江西农业大学，江西南昌330045 |
|
| Author | Institution |
| LIAO Yi-feng | Institute of Information Engineering, Shaoguan University, Shaoguan 512005 , China |
| HE Yi-song | Jiangxi Agricultural University, Nangchang 330045, China |
| XIONG Long-biao | Jiangxi Agricultural University, Nangchang 330045, China |
|
| 摘要点击次数: |
| 全文下载次数: |
| 中文摘要: |
| 研究了滚动轴承钢表面复合化学镀镍工艺，利用SEM分析了纯镍镀层、复合镀层的表面显微组织和相结构；采用HXZ-100显微硬度计和LY71-XM-200型表面形貌测量仪测试了镀层的硬度、耐磨性能，分析了其磨损机理。结果表明：热处理前镀层的结构是胞状突起，硬度为430.6HV；经热处理后，镀层为单一的纳米金刚石镍复合膜，均匀致密，硬度达到1 807. OHV，耐磨性大大提高；镀层的耐磨性随镀液中金刚石粉含量的不同而发生变化；镀层在19. 6N压力下研磨也不会发生脱落，表明其附着力极好，达到滚动轴承的表面性能要求。 |
| 英文摘要: |
| The craftwork of composite chemical Ni-plating on the roll bearing-steel was studied, the microstructure and phase structure of Ni and the composite film were analyzed by SEM, the micro-hardness and wear resistance were measured with HXZ-100 micro-sclerometer and LY71-XM-200 tWe surface morphology measure, and the wear mechanism was analyzed. The results show that the structure of plating-layer is cystiform protuberance before the heat treatment, the micro-hardness is 430.6HV; after it, the plating-layer is single nano-diamond composite film, uniformity and felsite, the micro-hardness is 1807.OHV, and greatly enhances the wear resistance; the wear resistance of platinglayer would take change along with different content of nano-diamond in the liquid ; the plating-layer doesn't fall off under 19.6 N stress; it shows the excellent adhesion reaches the exterior capability of rolly bearing. |
| 查看全文 查看/发表评论 下载PDF阅读器 |
| 关闭 |
|
|
|
渝公网安备 50010702501715号